4 INCH LOWERING BLOCK KIT

Description

Belltech Lowering Blocks provide an inexpensive, easy to install way to lower your Mini Truck by increasing the distance between the leaf spring and the axle, effectively lowering the vehicle. Belltech lowering block kits are manufactured of high-quality extruded aluminum and come complete with blocks, U-bolts, Nyloc nuts and washers. The extruded aluminum process yields higher strength ratings when compared to cast or steel lowering blocks (or other methods of manufacturing). Lowering blocks are designed to lower the rear of your vehicle in 1,2, 3- or 4-inch increments. Also available with built in 2-degree taper for drive line angle correction.

Since 1983 small company in Fresno, California had an idea to build the "best performing" lowering suspensions for the Chevrolet pickup. Fresno had been a haven for lowered vehicles and trucks were in abundance. Trucks were being lowered but their suspensions were terrible and not very roadworthy. Springs were either replaced with new ones not necessarily meant for the application and even worse they may be cut or heated with a torch at the local muffler shop to give the lowered stance that was cool. The stance looked good but the ride was terrible.

Fitment

This part fits the following vehicles.

• 2004-2012 Chevrolet Colorado
• 2004-2012 GMC Canyon

Features & benefits

• 4' drop block kit
• Fits most mini/mid-size trucks w/ 3" axle tube
• Extrude aluminum construction
• U-bolts and grade 8 hardware included
• Safe/economical solution
• Extrude alluminum construction
• Ships in 1 box

Specifications

Videos and guides

Magnuson-Moss Warranty Act

Legally, a vehicle manufacturer cannot void the warranty on a vehicle due to an aftermarket part unless they can prove that the aftermarket part caused or contributed to the failure in the vehicle (per the Magnuson Moss Warranty Act (15 U.S.C. 2302(C)).