PB B'laster is safe for use on your firearms. It does well at cleaning and also leaves behind a petroleum oil that lubricates and protects from corrosion. However, hunters have claimed that deer will smell it "a mile away."
It depends on the density of the rubber or plastic. Low density (flimsy) rubbers and plastics will deteriorate from long-term exposure to PB. Higher density rubbers and plastics may have some surface softening, but this will not affect its structural integrity.
PB will not affect a factory-quality finish. Lower quality re-paints may be affected. Company recommend testing on an inconspicuous area before using PB around such a finish.
PB B'laster is safe on all metals, including brass, copper, aluminum, etc.
Every situation is different, so there is no hard and fast rule. In general, the more time you give it to work, the better. Repeated application over a period of days is most effective. The application of heat will accelerate the process.
Time and ventilation are your greatest allies. The ingredients that cause the odor are volatile (which is a fancy way of saying they evaporate easily at normal temperatures), and the odor will decrease over time as part of that process.
To speed up the process, you can remove as much of the excess PB as possible with hot water and grease-cutting dishwashing detergent. For fabrics, baking soda or powdered carpet fresheners may help.
You can also help the volatiles evaporate more quickly through the application of heat (by a hairdryer for instance).
B'laster aerosol products have a shelf life of three years from the date of manufacture, during which company offer a warranty for cans that fail to dispense as designed.
The date of manufacture is found either etched into the paint toward the top of the label (approximately ½” below the bottom of the cap) or printed on the bottom of the can. It follows the YYJJJ format (the first two digits are the last two digits of the year and the next three digits are the day of the year. 16041, for example, would be the 41st day of 2016).
More information, including certain exclusions and what B'laster needs to process your warranty, can be found at blastercorp.com/shelf-life-and-sprayout-warranty-blaster-aerosol-products.
The date of manufacture is found either etched into the paint toward the top of the label (approximately ½” below the bottom of the cap) or printed on the bottom of the can. It follows the YYJJJ format (the first two digits are the last two digits of the year and the next three digits are the day of the year. 16041, for example, would be the 41st day of 2016).
No. While B'laster Silicone Lubricant cures tack-free and will not collect dust or dirt, it initially sprays out in liquid form. B'laster Dry Lube with Teflon goes on as a powder.
Silicone is the only active ingredient in B'laster Silicone Lubricant. However, the product also contains petroleum distillates, which act as a carrier in order for the product to be sprayed out as an aerosol.
While Company know of no issues associated with the use of Company Silicone Lubricant on treadmill belts, Company suggest following the recommendations in your treadmills owners manual.
Company first suggest you consult the owners manual that came with your garage door and opener regarding lubrication. However, Company Garage Door Lubricant can typically be used on the mechanical components of your garage door, including rollers, tracks, springs, cables, chains and hinges.
Company also recommend that you consult your owners manual and follow their recommendations. If they recommend a light-duty lubricant, Blaster Garage Door Lubricant is acceptable. Most chain drives require a grease lubricant; Blaster Garage Door Lubricant is not an adequate substitute for grease. Company Garage Door Lubricant can, in fact, displace grease from a drive chain and should be used with caution.