Vortex Clip-Ons are an economical replacement handlebar with amazing strength. They are machined from solid billet with a removable handlebar. In the event of a crash, you simply replace the handlebar tube instead of the entire Clip-on. Vortex handlebars come in 0 and 7 degree angles. Kit includes both collars, 2 handlebar tubes with plastic ends and high tensile strength fasteners. Note: Vortex Bar End BE118K will also work with Vortex Clip-on tubes
Vortex Clip-ons are for race use only. On certain motorcycle models modification of the surrounding components may be required. Clip-on size is determined by measuring the diameter of the fork tube where the Clip-on will be
installed. For the most acurate measurement always use calipers to measure the fork tubes. Do not attempt to install Vortex Clip-ons over any part of a fork tube that is tapered.
This image shows a typical installation of Vortex Clip-ons. Clamp bolts must be orientated as shown in this image for proper installation geometry and function. Since Vortex Clip-ons have different geometry than stock parts interference with other components may occur. Once the installation is complete it is
critical that the user checks for any possible interference over the FULL RANGE of steering movement prior to riding the motorcycle.
V3 Oversize Handlebar