Factory Ignition Covers

Description

Gives your bike the Factory Works look and sets your ride apart from the rest with the ultimate in race performance

Boyesen ignition covers are cast from the highest grade of lightweight aluminum, providing solid engine protection and are guaranteed not to warp

Individually surfaced to insure a perfect fit and seal properly, guarding the inside of engine from dirt and water; super tough powder coating resists wear and tear, outlasting stock covers

Asbestos-free gasket is bound with nitrile for tight, leak-free seal

Magnuson-Moss Warranty Act

Legally, a vehicle manufacturer cannot void the warranty on a vehicle due to an aftermarket part unless they can prove that the aftermarket part caused or contributed to the failure in the vehicle (per the Magnuson Moss Warranty Act (15 U.S.C. 2302(C)).

California residents

WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.