Product Details
Carbon Glaze by Dr. Beasley's®. A polishing glaze designed specifically for carbon fiber, Carbon Glaze uses light abrasives to eliminate hazing and micro-marring without damaging the gelcoat, leaving carbon fiber surfaces with an incredible, mirror-like gloss. If you want to unlock the full potential of your vehicle carbon fiber, you'll want to grab a tube today.
Features
- Lightly abrasive formula to preserve gelcoat
- Eliminates hazing, micro-marring and wash marks
- Leaves mirror-like gloss perfect for coatings
- Proudly manufactured in the USA
- Engineered with the breakthrough technology
- Designed to stringent standards for quality
Why Carbon Glaze?
Carbon Glaze is a polish designed to improve the appearance of carbon fiber. But why a polish just for carbon fiber?
Polish Out Blemishes Without Damaging Surface
Carbon fiber accents, trim and paneling have been popping up everywhere on cars for the past couple decades. But like any other surface on a car, they're susceptible to micro-marring, hazing, holograms, swirling, wash marks, you name it. When dealing with clear-coated paint, these aren't too difficult to polish out. But on the soft gelcoat used on most carbon fiber, you need to be extra careful not to polish too hard or risk exposing the inner fiber. Dr. Beasley's Carbon Glaze makes this easy, as it's made with light abrasives designed to eliminate minor blemishes without cutting too deep. You'll be able to polish out those irritating scratches while keeping your carbon fiber intact.
Give Your Carbon Fiber A Striking Gloss
Carbon fiber looks gorgeous when you 1st take your car home. It's glossy, pristine and smooth to the touch. But over time, even the shiniest carbon fiber starts to haze, with a milky translucent fog slowly overtaking the surface. But it's not just the haze that dulls your gloss - fine scratches, holograms and swirling all do the same. To get that gloss back, Carbon Glaze is the way to go. When used to polish your Carbon Fiber, it totally eliminates the dulling blemishes in its surface, leaving it with a deep, reflective gloss that'll make you forget it had ever dulled in the 1st place.
Perfecting For Coating Prep
It's often said in the detailing world that a coating is only as good as the surface underneath it. That goes for carbon fiber, too. If you want your carbon fiber's coating to bond as well as possible and get you the gloss you're looking for, you'll want to start with a surface that's been properly polished and decontaminated. And when it comes to carbon fiber, the best way to polish is with Carbon Glaze. It'll eliminate all the fine scratching on your carbon fiber's gelcoat, leaving you with a surface that's perfectly primed for coating with Formula 1201 or PlasmaCoat.
How Does It Work?
Carbon Glaze works by using light abrasives to cut out miniscule scratches and hazing in the gelcoat of a carbon fiber surface. Once polished, the glossy finish can be sealed with a coating like Formula 1201 or PlasmaCoat.
Application Instructions
1. Apply Carbon Glaze to a foam polishing pad.
2. Buff surface evenly with a polishing machine.
3. Remove residue with a clean microfiber towel and repeat if necessary.
Additional Tips
For best results, protect carbon fiber afterward with Dr. Beasley's Formula 1201 or PlasmaCoat.
Before applying, test a small amount in an inconspicuous place to check compatibility with surface.
Dr. Beasley's® a team of detailers, chemists, enthusiasts, and car nuts who design, formulate, and manufacture detailing products. Dr. Beasley's set out to create the best detailing products available. Choosing high quality ingredients while eliminating harmful chemicals from Dr. Beasley's formulas allows us to produce the safest, highest quality products possible. There's a better way to detail your car. Let us show you how.