Form-A-Shield 42in x 48in Non-Adhesive

Description

Form-A-Shield(TM) solves the problem of needing a direct contact, extreme heat barrier. Capable of withstanding direct heat of up to 1400°F+, Form-A-Shield(TM) was designed to provide the best possible heat protection in areas where high temperatures are always present and problematic. Form-A-Shield(TM) can be applied to exhaust headers, manifolds, turbo housings, and downpipes dramatically reducing radiant exhaust temperatures. Formed from 10 mil dimpled aluminum bonded to a high temperature rated basalt thermal barrier material, Form-A-Shield(TM) can be applied directly to hot surfaces helping to lower under hood temperatures while keeping more heat in the exhaust system. Extremely pliable and forms to many shapes and configurations Durable and resistant to oil and chemical spills Withstands direct heat up to 1400°F+ Superior insulator anywhere near the path of exhaust pipes Can be applied directly to hot surfaces Ideal for firewalls, exhaust manifolds, under-vehicle, floor pans, oil tank box areas, transmission tunnels, wrapping fuel cells, under hoods & more Fasten with straps, clamps or DEI Locking Ties No adhesive backing NOTE: Use DEI Adhesive Spray with Form-A-Shield on non-hot areas to serve as a heat barrier / reflector

Design Engineering, Inc.(TM) is one of the foremost suppliers of thermal tuning product featuring products for racers, street performance enthusiasts, and hobbyists alike. In addition to supplying the performance aftermarket with thermal tuning products, Design Engineering serves the needs of the powersports, marine, industrial and commercial industry markets the world over.

Features & benefits

• Constructed From 10 Mil Aluminum Bonded To 1/4 in. Basalt Mat
• Extremely Pliable And Forms To Many Shapes And Configurations
• Ideal For Firewalls/Exhaust Manifolds Transmission Tunnels
• Superior Insulator Anywhere Near The Path Of Exhaust Pipes
• Durable And Resistant To Oil And Chemical Spills
• Fasten With Straps/Clamps Or DEI Locking Ties
• Withstands Direct Heat Up To 1400 Degrees F
• Can Be Applied Directly To Hot Surfaces
• 42 in. x 48 in Shield
• No Adhesive Backing

Specifications

Warranty

1 Year

Videos and guides

Magnuson-Moss Warranty Act

Legally, a vehicle manufacturer cannot void the warranty on a vehicle due to an aftermarket part unless they can prove that the aftermarket part caused or contributed to the failure in the vehicle (per the Magnuson Moss Warranty Act (15 U.S.C. 2302(C)).

California residents

WARNING: This product contains a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov